EasyManua.ls Logo

Wacker Neuson ET18 - Fuses and Relays; Battery Condition; Charging the Battery; Replacing the Battery

Wacker Neuson ET18
298 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-46 OM ET18/20/24 us 1.3 * et18_20_24w710.fm
7
Fuses and relays
Blown fuses indicate overloading or short circuits. Have the electrical
system checked by a Wacker Neuson service center.
Only use fuses with the specified load capacity (amperage).
see chapter “ Relays” on page 9-5
see chapter “ Fuses” on page 9-5
Battery condition
May only be performed by a Wacker Neuson service center.
Charging the battery
May only be performed by a Wacker Neuson service center.
Replacing the battery
The battery is located under the left-hand cover.
The battery is “maintenance-free”. However have the battery checked at
regular intervals to ensure that the electrolyte level is between the MIN
and MAX marks.
Checking the battery requires it to be removed and must be performed by
a Wacker Neuson service center.
Always follow the specific battery safety instructions.
Notice
In order to avoid damage to the engine electronics, do not
disconnect the battery while the engine is running.
Fig. 264: Replacing the battery
- +

Table of Contents

Related product manuals