Wacker Neuson ET18 - Brake System; Information Regarding the Washer System; Checking the Fluid Level and Adding Fluid; Install the Fresh-Air Filter

7-48 OM ET18/20/24 us 1.3 * et18_20_24w710.fm
7
4. Install the filter.
5. Tighten cover B
7.15 Washer system
Information regarding the washer system
Only use glass cleaner (with antifreeze if necessary) for refilling.
Checking the fluid level and adding fluid
The tank filler inlet is located in the cab.
1. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
2. Check the fluid level in tank A and add fluid if necessary.Axles/
traveling drive.
Have maintenance only performed by a Wacker Neuson service center.
7.16 Brake system
Have maintenance only performed by a Wacker Neuson service center.
Fig. 266: Install the fresh-air filter
Fig. 267: Fluid level
A