9-14 OM ET18/20/24 us 1.3 * et18_20_24t900.fm
9
9.14 Payload/stability
Safety instructions – lift capacity table
The values of the lift capacity table apply to normal operation (for example
excavating, etc.) (The values of the stability table apply to lifting gear
applications).
Crushing hazard due to tipping over of the machine.
Causes severe crushing or injury resulting in death.
► The authorized lift capacity specified in the table must never
be exceeded (the smallest value applies).
► Get informed on the lift capacity of the attachment before
using it.
► If a bucket or attachment (hammer, etc.) is installed, the dead
weight and the contents of the bucket must be subtracted
from the lift capacity specified in the table. Load density must
also be taken into account.
If the specified lift capacity is exceeded, possible damage to
property due to tipping over of the machine.
► The authorized lift capacity specified in the table must never
be exceeded (the smallest value applies).
The indications are only approximate values. Attachments,
uneven ground and soft or bad ground conditions affect lift
capacity. The operator must take these influences into account.
To Next Page
Loading...
