OM ET18/20/24 us 1.3 * et18_20_24w700.fm 7-31
7
The fuel system can be bled automatically even if the engine is
at operating temperature
– see chapter “ Bleeding the fuel system” on page 7-28.
1. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
2. Open the engine cover.
3. Connect a drain hose to port F. Place the hose into a container on the
ground.
4. Open screw G.
5. Collect the fuel/water mixture in a suitable container.
6. Close screw G.
7. Remove the hose.
8. Close and lock the engine cover.
Use a suitable container to collect engine/machine fluids as they
flow out and dispose of them in an environmentally friendly
manner.
To Next Page
Loading...
