2-12 BA 357-00 * 3.0 * Sicherheit_E.fm
2 Safety
2.7 Attachment operation
Attachments
• Use only attachments that are certified for the vehicle or its protective
device (for example a shatter protection).
• All other attachments require the vehicle manufacturer’s release.
• The danger zone and the work zone depend on the attachment
used – see the Operator’s Manual of the attachment.
• Secure the load.
• Do not overload attachments.
• Check the correct position of the lock.
Operation
• Carrying persons on/in an attachment is prohibited.
• Installing a work platform is prohibited.
- Exception: The machine is equipped with the necessary safety
equipment and certified for operation.
• Attachments and counterweights modify handling, as well as the
steering and braking capability of the machine.
• The operator must be familiar with these modifications and
act accordingly.
• Before starting work, operate the attachment to check that
it works correctly.
• Before putting the attachment into operation, ensure that
nobody is in danger.
• Lower the attachment to the ground before leaving the operator's seat.
Removing and fitting attachments
• Before uncoupling or coupling hydraulic connections:
- Turn off the machine.
- Release the pressure of the work hydraulics.
• Picking up and lowering attachments to the ground
requires special care:
- Pick up and safely lock the attachment in accordance
with the Operator’s Manual.
- Lower the attachment only to firm, level ground and secure it to
prevent it from tipping over or rolling away.
• Put the vehicle and the attachment into operation only if:
- The protective equipment has been installed and is functional.
- The connections for the lights and the hydraulic
system have been established and are functional.
• Perform a visual check of the lock after locking the attachment.
• There must be nobody between the vehicle and the
equipment when picking up or lowering an attachment to the ground.
To Next Page
Loading...
Need help?
General
