BA 357-00 * 3.0 * 35700_08_Betriebsstörung.fm 8-3
Malfunctions 8
8.3 Malfunctions of the electrical system
Important information
Repairs on the electrical system may only be performed by an authorized
service center.
See also Electrical system on page 7-61.
Error display of machine electronics in gauge
The warning lights 38 and 39 indicating errors that are recorded by the
machine electronics.
If an error occurs in the electronics of the travel drive or work hydraulics,
which is not displayed 45 via its own indicator light, then an error message
is displayed for 3 seconds as an error code in field F in the indicating
instrument.
Make a note of the error code!
The error code is saved and can be recalled at any time
– see chapter 7 “Error code display” on page 7-11.
Ignoring error messages can cause technical damage!
► Proceed as specified in the error code table
– see "Error code tables" on page 8-8.
► If the error is not removed by the described measure, get in touch with
and authorized service center.
Critical error: red warning light 39 illuminates continuously!
To avoid further damage to the travel drive and/or the work hydraulics:
► If possible, drive the machine out of the danger zone.
► Lower the loader unit to the transport position.
► Turn the machine off and remove the ignition key.
► Get in touch with an authorized service center and
have the error rectified.
Possible causes of an error code
• Open wiring, interruption.
• Overvoltage, undervoltage.
• Grounding contact error.
• Malfunctioning component.
• Allowed values exceeded/not reached
(temperature, pressure, velocity, sensor error due to dirt deposits etc.).