BA 357-00 * 3.0 * 35700_04_Inbetriebnahme_03.fm 4-35
Putting into operation 4
Indicator light (blue) – high beam
The indicator light 42 illuminates if the high beam
is switched on or if the headlight flasher is actuated
– see "High beam/headlight flasher" on page 5-20.
Warning light (red) – temperature
A warning signal sounds and the warning light 43 illuminates if the
allowable temperature of one of the following components has been
exceeded:
• Hydraulic oil
• Electric motor of travel drive (hydraulic motor)
• Electric motor of work hydraulics (operating motor)
• Power electronics/machine controller
The warning light 43 flashes if the maximum allowable temperature from
one of the mentioned components is exceeded.
In the digital display 45in area G there is a display of which component is
affected – see "Main display" on page 4-38.
If the power electronics are overheated, the warning light 43 illuminates.
An additional symbol appears in the digital display.
Depending on the temperature measured, the performance of the
overheated component is reduced, in order to protect the machine against
damage.
➥ If the warning light lights up during operation, turn off the machine
and let it cool down. If the error occurs again, contact an authorized
service center.
To Next Page
Loading...
Need help?
General
