7-28 BA 357-00 * 3.0 * 35700_07_Wartung.fm
7 Maintenance
7.6 Lubrication work
Lubricating the rear axle oscillation-type bearing
Maintenance intervals – see "Maintenance plan" on page 7-6.
Lubricant – see chapter 7 “Fluids and lubricants” on page 7-14.
1. Park the machine on level ground.
2. Apply the parking brake.
3. Secure the machine with a wheel chock.
4. Only raise the loader unit until all zerk fittings
can be accessed without any risk.
5. Switch off motor isolating switch.
6. Turn the machine off and remove the ignition key.
7. Lubricate grease zerk A of the oscillation-type bearing.
Lubricating the planetary drive bearing (front and rear axles)
Maintenance intervals – see "Maintenance plan" on page 7-6.
Lubricant – see chapter 7 “Fluids and lubricants” on page 7-14.
1. Park the machine on level ground.
2. Apply the parking brake.
3. Secure the machine with a wheel chock.
4. Only raise the loader unit until all zerk fittings
can be accessed without any risk.
5. Turn the steering wheel for better access.
6. Switch off motor isolating switch.
7. Turn the machine off and remove the ignition key.
8. Lubricate grease zerks B (2 x) on each planetary drive bearing.
To Next Page
Loading...
Need help?
General
