BA 357-00 * 3.0 * 35700_07_Wartung.fm 7-27
Maintenance 7
The following aids are recommended for cleaning:
•Water
• Moist cloths (made of cotton or paper)
Cleaning
1. Place a suitable container below to catch possible resulting
flush water that may contain electrolytes; dispose of this water in an
environmentally friendly manner.
2. Clean the plastic parts of the battery with water-soaked
cleaning cloths that do not contain any additives.
3. Dry the battery surface appropriately, e.g. with compressed
air or anti-static linen cloths.
Checking threaded fittings
• Check all threaded fittings regularly, even if they are not listed in the
maintenance plans.
• Immediately tighten loose connections. See chapter
"Technical data" for the tightening torques.
Maintenance intervals – see "Check bolts and nuts for tightness, re-
tighten them if necessary:" on page 7-10.
Checking pivots and hinges
• Lubricate all mechanical pivot points on the machine
(for example door hinges, joints) and fittings (for example door
arresters) regularly, even if they are not listed in the lubrication plan.
• Check the accelerator and brake pedals for dirt, clean them if
necessary, apply spray oil to the joints.
Maintenance intervals – see "Maintenance plan" on page 7-6.
To Next Page
Loading...
Need help?
General
