2-18 BA 357-00 * 3.0 * Sicherheit_E.fm
2 Safety
Measures for performing maintenance
• Perform only the maintenance described in this Operator’s Manual.
• All work that is not described in this operator’s manual must be
performed by qualified and authorized, technically trained personnel.
• Follow the maintenance plan – see “Maintenance plan”.
• Always use specially designed or otherwise safety-oriented ladders
and working platforms to perform overhead maintenance.
Do not use vehicle parts or attachments as a climbing aid.
• Do not use attachments/work equipment as a lift platform for persons.
• Remove all dirt, snow and ice from climbing aids
(for example, handholds, footholds, handrails).
• Disconnect the battery connector from the machine connection before
working on the electrical system.
Modifications and spare parts
• Do not modify the machine and the work equipment/attachment
(for example, the safety devices, lighting, tires, straightening and
welding work).
• Modifications must be approved by the manufacturer and performed by
an authorized service center.
• Use only original spare parts.
Protective structures
• The cabin, rollbar and protective screen are tested protective
structures and may not be modified (for example no drilling, bending,
welding).
• Perform a visual check according to the maintenance plan
(for example, check the fastenings for damage).
• If damage or defects are detected, have them immediately
checked and repaired by an authorized service center.
• Have retrofitting work only performed by an authorized service center.
• Replace self-locking fasteners (for example self-locking nuts) by new
ones after removing them.
To Next Page
Loading...
Need help?
General
