BA 357-00 * 3.0 * Sicherheit_E.fm 2-21
Safety 2
Working near electric supply lines
• Before performing any work, the operator must check whether there
are any electric supply lines in the job site.
• If there are electric supply lines, only a vehicle with cabin may be used
(Faraday cage).
• Keep a safe distance from existing electric supply lines.
• If this is not possible, the operator must take other safety measures
(for example, switching off the current) in agreement with the operating
company or owner of the supply lines.
• If supply lines are exposed, they must be fastened, supported and
secured accordingly.
• If live supply lines are touched nevertheless:
- Do not leave/touch the cabin (Faraday cage).
- If possible, drive the machine out of the danger zone.
- Warn others against approaching and touching the machine.
- Have the live wire de-energized.
- Do not leave the vehicle until the supply lines that have been
touched or damaged have been safely de-energized.
Working near non-electric supply lines
• Before performing any work, the operator must check whether there
are any non-electric supply lines in the job site.
• If there are non-electric supply lines, the operator must take safety
measures (for example, switching off the supply line) in agreement with
the operating company or owner of the supply lines.
• If supply lines are exposed, they must be fastened, supported and
secured accordingly.
Behavior during thunderstorm
• Stop machine operation if a thunderstorm is gathering, stop the
machine, secure and leave it, and avoid being near it.
To Next Page
Loading...
Need help?
General
