BA 357-00 * 3.0 * 35700_07_Wartung.fm 7-79
Maintenance 7
Removing the wheel
1. Park the machine on level and firm ground.
2. Lower the loader unit to the ground.
3. Apply the parking brake.
4. Turn the machine off and remove the ignition key.
5. Prevent the machine from rolling away (wheel chocks).
6. Loosen the wheel nuts a little of the wheel you want to remove.
7. Place the jack on the axle next to the wheel to be changed so that the
jack cannot slide down.
8. Raise the machine with the jack only until the wheel can be moved
freely.
9. Put a jack stand under the axle tube ensuring stability.
10.Lower the machine onto the jack stand.
11.Completely remove the wheel nuts.
12.Remove the wheel.
Mount the wheel
1. Clean the flange surfaces of the wheels and axles.
2. Place the covering sleeves onto the wheel bolts.
3. Place the wheel onto the wheel bolts with a suitable means.
4. Remove the covering sleeves.
5. Fit all the wheel nuts and tighten them part-way.
6. Lower the raised axle.
7. Tighten all of wheel nuts crosswise with the specified torque
– see chapter 9 “Tightening torques” on page 9-14.
Re-tighten the wheel nuts after 10 operating hours to
the specified torque.
To Next Page
Loading...