7-86 BA 357-00 * 3.0 * 35700_07_Wartung.fm
7 Maintenance
Measures for maintaining anticorrosive protection
Special hazards during anti-corrosion protection!
Handling chemical substances can cause serious injury or death.
► When handling chemical substances of any kind, such as solvents,
wax, etc., observe the specific product-related safety regulations
(safety data sheet).
► Ensure sufficient room ventilation.
► Do not use unprotected lights or open flames.
► Do not smoke.
► Only work on the electrical system if the battery connector has been
disconnected!
Maintenance intervals – see "Maintenance plan" on page 7-6.
Cleaning
Contrary to the instructions in section„Cleaning and maintenance“ on
page 7-19, do not clean machines with anticorrosion protection with a
bristle brush nor with a steam jet or a high-pressure cleaner!
► If cleaning the machine with these means cannot be avoided, check
the wax coating very carefully and have it renewed or reapplied as
required.
• If the machine is used in corrosive environment over a longer period of
time, remove the floor mat in the cabin. This will avoid a collection of
corrosive moisture.
• Thoroughly clean machines that are put out of operation over a longer
period of time.
• Clean the machine at least once a week. In particular, remove
corrosive deposits (such as salt crusts) as fast as possible.
• Clean the machine with cold running water preferably.
To Next Page
Loading...