BA 357-00 * 3.0 * 35700_03_Einleitung.fm 3-7
Introduction 3
Steering system
The standard machine is equipped with 4-wheel steering.
Front axle steering is optionally available.
Brakes
The service brake consists of a brake disc, which is located on the input
shaft of the front axle. Through the cardan shaft, it also works on the rear
axle. The service brake is activated via the braking pedal. In addition, the
machine is braked electromagnetically by the hydraulic motor when the
accelerator pedal is released.
The parking brake is designed as a spring-applied brake.
The spring-applied brake can be activated either
automatically or manually.
The automatic activation of the spring-applied brake is carried out in two
steps: hold function (active standstill control) and park function.
The hold function prevents the machine from rolling backwards on the
slope. The park function applies if no machine travel occurs for more than
3 seconds, the operator presence switch is triggered or the machine is
switched off.
The hold function retains the machine at an incline of up to 18%.
In addition, the spring-applied brake can be activated
manually by means of a switch.
Loader unit
The loader unit consists of the lift frame with an integrated
hydraulic quickhitch for the attachments, lift and tilt
cylinders and the corresponding attachments.
To Next Page
Loading...
Need help?
General
