LTN Assembly Appendix VI—CE Racked Assembly
wc_tx001217gb.fm 101
14 Appendix VI—CE Racked Assembly
Overview
This set of assembly instructions applies to CE machines shipped on a container
rack as shown below.
If your machine does not look like the one shown in the illustration, refer to Machine
Identification in the Introduction chapter to identify the appropriate set of assembly
instructions.
Tasks
To complete the assembly of your Light Tower, the following tasks must be
performed:
wc_gr006470
Task Description See topic
Chassis assembly
1 Attach the outriggers and outrigger jacks 14.1
2 Attach the rear jack 14.2
Tower assembly
3 Attach the tower lock bracket 14.3
4 Attach the tower cradle 14.4
5 Attach the tower 14.5
6 Attach the tilt winch cable 14.6
Lights assembly
7 Attach the light mount bracket and light bar 14.7
8 Attach the light fixtures 14.8
Electrical assembly
9 Wire the junction box 14.9
10 Route the coil cord 14.10
11 Wire the ballasts and terminal strips 14.11