Appendix IV—CE Pallet Assembly LTN
80 wc_tx001215gb.fm
12.1 Installing the Side Jacks
Procedure
Follow the procedure below to attach the two side jacks. (Use the same procedure
for each side jack.)
1. Locate the two 15-inch travel jacks (C).
2. If necessary, remove the locking pin (C3) from the holes in the jack.
3. Fit the jack socket (C1) over the circular end of the outrigger (B).
4. Rotate the jack so that the foot (C2) rests on the ground.
5. Align the top hole in the socket with the top hole on the outrigger.
6. Insert the locking pin into the holes. Push the locking pin through both sets of
holes (top and bottom) to fasten the jack in place.
wc_gr006710
C
B
C1
C3
C2
To Next Page
Loading...
Need help?
General
