Operation LTN 6L
38 wc_tx000766gb.fm
4.6 Lowering Tower (Manual Winch System)
See Graphic: wc_gr005075
Be sure to read and understand the operating instructions before
lowering the tower!
If for any reason a part of the tower hangs up or a winch cable develops
slack before tower is fully lowered, stop immediately! Continuing to
turn the winch handle will increase the slack in the cable. Too much
slack could cause the tower to collapse should it suddenly free up. If
the tower hangs up, level the trailer. Slightly shake or twist the tower
assembly to free the bind. Contact an authorized Wacker Neuson
service representative immediately.
NEVER lower the tower while the unit is operating.
NEVER allow anyone to stand near the rear of the unit while lowering
the tower.
4.6.1 Turn the lights off. Shut down the engine.
NOTICE: Shutting down the engine before turning off the lights could
damage floodlight ballasts or generator capacitor(s).
NOTICE: Observe power cord while lowering the tower. Make sure the
coiled cord is not damaged during the lowering process.
4.6.2 Lower the tower by turning the handle on the telescoping winch (q)
counterclockwise (“cable out” direction).
NEVER touch the winch pawl! Releasing the winch pawl may cause
the tower to fall.
4.6.3 Loosen the rotation locking knob (s) and rotate the tower so the
winches are facing toward the trailer tongue.
WARNING
WARNING
WARNING
WARNING
To Next Page
Loading...
Need help?
General
