Maintenance
Transmission
BA RD24_RD27 en 04
155
NOTICE
Increased material wear!
Material damage through increased wear on tyres, running gear and
drive parts as a result of a combination of different tyres on each axle.
■
On one axle, only mount and use tyres that are the same type and
have the same design, profile and diameter.
■
Always adjust the tyre pressures on one axle to the same value.
Preparation
Put machine on a safe surface (even, capable of bearing, horizontal)
and secure against rolling away
Switch off diesel engine and remove ignition key.
Have hoisting gear ready that is appropriate for the weight of the
machine and wheels.
Lift the machine until the wheels leave the ground:
■
Apply a jack with sufficient lifting capacity to the marked lifting
points on the chassis, or
■
Lift the machine only by the marked suspension points using
suitable hoisting gear (crane with round sling/chain).
Put/jack machine on the machine frame on liners capable of bearing
(tyres may not be in contact with the ground).
NOTE
Only persons familiar with changing tyres and aware of
dangers are allowed to change the tyres.
When jacking up the machine, use only stable liners capable of
bearing (e.g. support timber of sufficient size).
Perform the work with two fitters!
To Next Page
Loading...
Need help?
General
