Operation
Loading and transporting
62
BA RD24_RD27 en 04
Load securing
Special notes
■
Variant
and variant
may be combined. The lashing devices
must not necessarily be arranged crosswise.
■
Do not use any lashing device unless it is of sufficient dimension,
bears the corresponding marking, and has been subjected to a valid
inspection.
■
Lash the machine with appropriate lashing devices onto the loading
area, using only the marked lashing eyes.
■
Observe the load for the lashing point(s) at the vehicle/load platform
and at the load/roller. Do not overload the lashing points with a
tensioning device (see the loading chart).
■
To increase load safety, use additional precautions for securing the
load including, e.g., wheel stop wedges, or a positive fit at the goose-
neck.
NOTE
Store the machine on the load platform, placing two
continuous and clean strips of anti-slide mats (grammage
approx. 10 kg/m², loadable up to 630 t/m², 10 mm thick,
friction factor µ ≥ 0.6) under every roller drum/tyre.
To Next Page
Loading...
Need help?
General
