WAGNER PEM-X1 Translation Of The Original Operating Manual

Operating manual Powder Cup Gun PEM-X1 CG
4 Basic Safety Instructions
Order number 2326960 | Edition 10/2022 15
4 on sharp edges
4 on moving parts
4 on hot surfaces
4 Ensure that the hoses are never run over by vehicles (e.g., fork lifts), or that the hoses
are never put under pressure from the outside in any other way.
4 Ensure that the hoses are never kinked. Observe maximum bending radii.
4 Ensure that no work is ever performed with a damaged hose.
4 Make sure that the hoses are never used to pull or move the device.
4.2.5 Electrical Connection Cables
Risk caused by improperly laid cables!
Risk of injury and damage to the device.
4 Properly lay connection cables and check them regularly.
4 Immediately replace damaged connection cables.
4 Ensure that no work is ever performed with a damaged connection cable.
4 Do not lay connection lines on travel paths of forklifts or through doors/gates.
4 Do not lay connection lines in the area of walkable hallways or paths to avoid the risk of
tripping.
4.2.6 Cleaning and Flushing
Danger due to cleaning and flushing!
Explosion hazard and damage to the device.
4 Before starting cleaning or any other manual work, the high voltage in the spray area
must be shut down and locked to prevent it from being switched back on.
4 Lock the compressed air supply and decompress the device.
4 Secure the device against being switched back on without authorization.
4 Use only electrically conducting and grounded tanks for cleaning fluids.
4 Preference should be given to non-ignitable cleaning fluids.
4 Ignitable cleaning liquids may only be used if all high-voltage parts are discharged to a
discharge energy of less than 0.24mJ after shutting off the high voltage before these
parts can be reached. Most ignitable solvents have an ignition power in the range of
0.24mJ, corresponding to 60nC.
4 The flash point of the cleaning agents must be at least 15K over the ambient
temperature.
4 Note the details provided by the powder lacquer manufacturer.
4 To correct for dust deposits, only mobile industrial vacuums of type1 may be used (see
EN60335-2).
4 Take measures for workplace safety (see Chapter "A Safe Work Environment").
4.2.7 Maintenance and Repair
Danger due to improper maintenance and repair!
Danger to life and equipment damage.
4 Only a WAGNER service center or a specially trained person may carry out repairs and
replace parts.

WAGNER PEM-X1 Specifications

General

Brand	WAGNER
Model	PEM-X1
Category	Paint Sprayer
Language	English