Operating manual Powder Cup Gun PEM-X1 CG
7 Operation
Order number 2326960 | Edition 10/2022 29
7.6.1 Pressure Relief / Work Interruption
4 Carry out the work steps in accordance with the chapter on pressure relief in the
operating manual of the corresponding device:
ð If a prompt for pressure relief is given.
ð If coating work is interrupted or stopped.
ð Before the device is externally cleaned, checked or serviced.
ð Before the spray nozzle is installed or cleaned.
7.7 REPRODUCIBLE SETTING OF THE NOZZLE POSITION
An adjustment tool is provided for the flat jet nozzle.
It permits turning the flat jet nozzle without damaging the electrodes and without removing
the union nut.
The union nut only has to be slackened.
To Next Page
Loading...
Need help?
General
