Wallace Perimeter Security SPEEDGATE - Page 47

SPEEDGATE Installation and Maintenance Manual Revision 1 - MAY 2023
47
SPEEDGATE INSTALLATION
5. Ensure minimum of 4” (10cm) thread exposed above foundaon. See chemical anchor installaon
guide accompanying the product for depth of anchor holes. HILTI anchors and epoxy are available
from Wallace Perimeter Security.
The installer shall read and follow the manufacturer’s wrien instrucons for HILTI HVU2 1” X 8 1/4”
accompanying the shipped adhesive capsule product. Refer to step-by-step diagram on the following
pages, summarized below.
SUMMARY OF DIAGRAM STEPS 1 TO 11:
STEPS 1, 2, 3 As indicated in diagram on following pages. (Place each steel anchor bolt template on
the prepared, leveled foundaons and center the conduits.)
STEP 4 On both concrete piles:
Drill two (non-corner) 1/2” by 2 3/4” deep holes directly opposite one another into
the pre-drilled steel anchor bolt template.
STEP 5 On both concrete piles:
Insert two wedge anchors into the 1/2” by 2 3/4” deep holes.
STEP 6 On both concrete piles:
In the four corners of each pre-drilled steel anchor bolt template, drill 1 1/8” by 9”
deep holes.
STEP 7 On both concrete piles:
Use a hand-operated air pump in combinaon with a hole-cleaning brush to clean
debris and dust from each of the drill holes prior to anchor installaon.
On both concrete piles:
Check the seng depth in each of the 1 1/8” by 9” deep (four-corner) hammer-drilled
holes. Ensure minimum of 4” (10cm) thread is exposed above the foundaon.
STEP 8 On both concrete piles:
Insert the HILTI foil (mortar) capsule with the peak ahead (tapered end) to the back
of the hole.
STEP 9 Using 1” grade 8 anchor bolts (or equivalent), embed the anchors; drive with plugged
tool into the hole(s). A nut and washer shall be ghtened on each anchor bolt.
STEP 10, 11 8 ¼” is the minimum depth for driving the anchor into the hole. Refer to manufacturer’s
instrucons for appropriate curing me.