Wallace Perimeter Security SPEEDGATE - Page 68

68
wallaceperimetersecurity.comPhone: 866.300.1110
WIRE SIZES, TYPES AND LOCATIONS
The electrical connecons for a SpeedGate are as follows:
Table 6. SpeedGate Electrical Connecons References
1. Conduit Between Primary and Secondary Columns
Run through header between Columns 1 and 2 for PDTT
(TOP TRACK) Model; OR 2” underground conduit between
Columns 1 and 2 for PDXT (TRACKLESS) Model.
• [PDTT] “PDXT, PDXT-C and
PDTT Electrical Point-to-Point
Diagrams - 1” on page 59
• [PDXT] “PDXT, PDXT-C and
PDTT Electrical Point-to-Point
Diagrams - 2” on page 61
• [PDXT-C] “PDXT, PDXT-C and
PDTT Electrical Point-to-Point
Diagrams - 3” on page 63
1.1 Low voltage wiring to Post Terminaon Box, excluding the
encoder and motor cables:
The Post Terminaon Box is in the column that is located
nearest to the Operator Cabinet. All of the gate safety inputs
except for the vehicle detector loop leads terminate into the
Post Terminaon box. The mul-conductor low voltage cable
connects the Post Terminaon box to the operator cabinet.
All wires from the secondary column terminate into the Post
Terminaon box located in the Primary Column.
• “Post Terminaon Box” on
page 86
Figure 13. Locaon of Post Terminaon Box