Wascomat Clarus Control SU620 - Page 146

146
Programme unit
ERROR, PRESS SENSOR TILT Y
ERROR, PRESSURE SENSOR TIMEOUT Y
ERROR, DOOR SWITCH TILT Y
ERROR, LEVEL OFFSET Y
ERROR, LEVEL SYSTEM NOT CALIB. Y
TIME DELAY BEFORE DOOR OPENING 0:30
UPPER TEMPERATURE FOR ERROR 98°C
LOWERTEMPERATUREFORERROR -9°C
MAX ADJUST TEMPERATURE 97°C
MAXIMUM EXTRACT SPEED 825
DEFAULT WASH SPEED 48
DISTRIBUTION SPEED 90
DEFAULT LOW EXTRACT RPM 550
DEFAULT MEDIUM EXTRACT RPM 700
DEFAULT HIGH EXTRACT RPM 900
START EXTRACT SPEED 1000
DEFAULT WASH ACCELERATION 20
1 2 3
4 5 6
7 8 9
0
ERROR, PRESS. SENSOR TILT Y
ERROR, PRESSURE SENSOR TIMEOUT Y
ERROR, DOOR SWITCH TILT Y
ERROR, LEVEL OFFSET Y
ERROR, LEVEL SYSTEM NOT CALIB. Y
TIME DELAY BEFORE DOOR OPENING 0:30
UPPER TEMPERATURE FOR ERROR 98°C
LOWERTEMPERATUREFORERROR -9°C
MAX ADJUST TEMPERATURE 97°C
MAXIMUM EXTRACT SPEED 825
DEFAULT WASH SPEED 48
DISTRIBUTION SPEED 1 90
DISTRIBUTION SPEED 2
DEFAULT LOW EXTRACT RPM 550
DEFAULT MEDIUM EXTRACT RPM 700
DEFAULT HIGH EXTRACT RPM 900
START EXTRACT SPEED 1000
DEFAULT WASH ACCELERATION 20
1 2 3
4 5 6
7 8 9
0
Default wash speed
Here you determine the wash speed the machine
will use at any time when it cannot find instruc-
tions for the correct wash speed, e.g. in the event
of manual operation.
Distribution speed
Here you determine the machine’s distribution
speed. The distribution speed is not programma-
ble when you create a wash program. Instead the
machine always uses the value you set here.
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .