Wascomat Clarus Control SU620 - Page 147

147
Programme unit
Speed
Default value, extraction time
Here you determine the various speeds (low, me-
dium and high) for extraction. The instructions for
determining the length of extraction times are to
be found earlier in SETTINGS 2.
How an extraction sequence works:
In order to extract some of the water from the
load at lower speeds, the drum does not acce-
lerate to its highest speed immediately. Instead
it accelerates in several steps. This means that
the drum first accelerates to a low speed level,
remains at that for a certain time, then accele-
rates to a higher level, extracts at that speed for
a certain time, and so on until it reaches its final
(maximum) extraction speed. If you program a
low extraction speed, the number of steps at
the beginning of the extraction sequence may
be reduced.
TIME DELAY BEFORE DOOR OPENING 0:30
UPPER TEMPERATURE FOR ERROR 98°C
LOWERTEMPERATUREFORERROR -9°C
MAX ADJUST TEMPERATURE 97°C
MAXIMUM EXTRACT SPEED 1200
DEFAULT WASH SPEED 48
DISTRIBUTION SPEED 90
DEFAULT LOW EXTRACT RPM 550
DEFAULT MEDIUM EXTRACT RPM 700
DEFAULT HIGH EXTRACT RPM 900
START EXTRACT SPEED 1000
DEFAULT WASH ACCELERATION 20
DISTRIBUTION ACCELERATION 9
RETARDATION ACCELERATION
EXTRACT ACCELERATION 40
START EXTRACT ACCELERATION 40
EXTRACT RETARDATION 50
1 2 3
4 5 6
7 8 9
0
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .
low
medium
high
Time
Start extract speed (i.e. Initial extraction
speed)
Here you determine the speed of initial extraction.
When you are creating a wash program you can
determine (under ”Main data”) whether it is to
begin with initial extraction. Initial extraction is
used to spin the load outwards against the drum
walls, which makes it absorb water more readily
on first filling. As a result of this the machine will
not require so much extra filling later.
There are two other functions affecting initial
extraction which can be programmed under SET-
TINGS 2:
• STARTEXTRACTTIME
• STARTEXTRACTACCELERATION
START EXTRACT SPEED 1000
DEFAULT WASH ACCELERATION 20
DISTRIBUTION ACCELERATION 9
RETARDATION ACCELERATION
EXTRACT ACCELERATION 40
START EXTRACT ACCELERATION 40
EXTRACT RETARDATION 50
MAX SPEED DURING FILLING 100
MAX LEVEL OFFS FOR AUT. CALIB.
TIME AT DISTRIBUTION SPEED 2
NUMBER OF REDIST LOW 1 UNB.
NUMBER OF REDIST LOW 2 UNB.
NUMBER OF REDIST MEDIUM UNB.
NUMBER OF REDIST HIGH UNB.
NUMBER OF REDIST EXTREME UNB.
DRAIN TIME AT PROGR. START
DRAIN TIME AT PROGR. END
READY
1 2 3
4 5 6
7 8 9
0
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .