IntroductIon
© WASP S.r.l.
3
24
Transport and handling
3
3 TRANSPORT AND HANDLING
3.1. General warnings
The reading of this chapter assumes, in order to use the printer safely, the knowledge of the contents of paragraph
1.6 “General safety warnings”.
Furthermore, the specific requirements for safe interaction with the printer, related to this chapter, are detailed
in the following paragraphs.
ATTENTION:
The operations related to these activities must be performed by authorized and professionally
qualified personnel.
ATTENTION:
During operations, the operator must wear all the necessary Personal Protective Equipment (PPE).
3.1.1. Delivery of the printer
Upon receipt, make sure that:
• The printer has not been damaged during transport;
• Any packaging has not been tampered with consequent removal of parts from the inside;
• The supply corresponds to the order specifications.
NOTE:
If the printer needs to be stored for a certain period of time before installing it, it is recommended to
protect it adequately and store it in a suitable environment (with a temperature between 0 ° C and 30
° C and relative humidity between 20 % and 60% non-condensing) and protected from atmospheric
agents in order to avoid deterioration.
ATTENTION:
During storage, never stack the boxes containing the equipment.
To Next Page
Loading...
