Wasp 3MT HDP - 1.2.1 Position of the Label; 1.3 Testing; 1.4 Warranty

IntroductIon
© WASP S.r.l.
1
8
1
1.3. Testing
The printer is tested directly by the Manufacturer during the phase of assembly and testing.
1.4. Warranty
The printers built by WASP S.r.l. are covered by warranty for a period of 12 months for companies or VAT and 24
months for individuals, according to the specifications set out in the sales contract.
If during the period of validity, defective operations or faults of parts of the printer that fall within the cases
indicated in the warranty occur, WASP S.r.l. (after the appropriate checks) will repair or replace the defective
parts.
The defective parts under warranty are repaired or replaced free of charge by WASP S.r.l. .
The costs of transport and / or shipment are always charged to the Customer, as well as the return / return travel
expenses related to the intervention of the Manufacturer’s technicians at the Customer’s premises.
The labor costs related to the intervention of the Manufacturer’s technicians at the Customer’s premises, for the
removal of defects under warranty are the responsibility of the Manufacturer, except in cases where the nature
of the defect is such that it can be easily removed on site by part of the Customer.
All consumables are excluded from the warranty.
The court of competent jurisdiction for any legal dispute is the Court of Ravenna, Italy.
NOTE:
The guarantee lapses in the following cases:
• Default or other contractual non-fulfillment;
• Improper use of the printer
• Failure to comply with the standards and maintenance intervals
• Tampering
• The printer is returned to the Manufacturer in a different packaging from the one supplied at the
time of purchase;
• Use of non-original spare parts, ie not supplied directly by the Manufacturer;
• Extraordinary interventions not carried out by personnel not sent by the Manufacturer;
• Any variation and / or non-observance of what is indicated in the technical documents and in
this manual entails the forfeiture of the technical and functional guarantees, and release the
Manufacturer of the printer from any responsibility.
1.2.1. Position of the label on the printer
The identification label can be found on the back profile of the printer on the top of the general switch.