Wasp 3MT HDP - 7.2 Ordinary Maintenance

IntroductIon
© WASP S.r.l.
6
44
Ordinary and extraordinary maintanance
6
7.2. Ordinary maintanance
Periodic maintenance and correct use are essential factors to ensure the functionality, safe operation and
durability of the printer. The maintenance interventions and the required interventions are carried out by the
mechanical maintenance technician who must operate in compliance with the safety instructions contained in
this manual.
ATTENTION:
The maintenance operations must be carried out by disconnecting the printer from the power
source by unplugging the power plug.
NOTE:
In case of replacement of components during maintenance, they must be replaced with identical
and original components.
Part Kind of intervention Period Procedure
Pellet filter Clean or replace 40 hours Par. 7.2.1
Belts Check tension 160 hours /
Ball joints Lubrication 160 hours Par. 7.2.2
Extruder fans Check if works 160 hours Par. 7.2.3
Sliders Check plays 160 hours Par 7.2.4
VACS Cleaning and checking integrity When needed Par 7.2.5
Nozzle Cleaning or replacing When needed Par 7.2.6
fig 7.2.1 a fig 7.2.1 b
Fig. 7.2.1- Cleaning the pellet filter