IntroductIon
© WASP S.r.l.
3
25
Transport and handling
3
3.2. Content
The printer is supplied with:
• Operating and maintenance manual
• USB pendrive
• Printing plates
• Vacuum gaskets
• Pellets
3.3. Unpacking, lifting and handling of the printer
ENVIRONMENTAL NOTE:
Once the packaging has been removed from the printer it is recommended to keep it for any
requests for assistance from the Manufacturer.
ATTENTION:
The weight of the printer is shown in paragraph 2.6 “Technical data”. It is therefore necessary to use
the lifting equipment whose expected flow is adequate for the weight to be lifted.
ATTENTION:
As long as the printer is not completely raised, it is advisable to check the correct balance of the
same. During lifting, all the area around the printer is considered dangerous.
ATTENTION:
All small equipment that exceeds the weight of 25 kg must be transported with the appropriate
equipment, or manually (if not exceeding 50 Kg) by two qualified operators.
ATTENTION:
The handling of the machine requires three properly qualified persons as mentioned above
With the help of a screwdriver or a electric screwdriver remove carefully all the screws on the box.
Remove the walls one by one, paying attention not to damage them.
To Next Page
Loading...
