Watlow CLS200 - Figure 2.7 - TB50 Mounted on a DIN Rail (Front); Figure 2.8 - TB50 Mounted on DIN Rail (Side)

CLS200 Series User’s Guide
Chapter 2: Installation
24
DIN Rail Mounting
Snap the TB50 on to the DIN rail by placing the hook side on the rail first, then pushing the snap
latch side in place. (See Figure 2.7.)
Figure 2.7 — TB50 Mounted on a DIN Rail (Front)
To remove the TB50 from the rail, use a flathead screwdriver to unsnap the bracket from the rail.
(See Figure 2.8.)
Figure 2.8 — TB50 Mounted on DIN Rail (Side)
Mounting with Standoffs
1. Remove the DIN rail mounting brackets from the TB50.
2. Select a location with enough clearance to remove the TB50, its SCSI cable and the controller
itself.
3. Mark the four mounting holes.
4. Drill and tap four mounting holes for #6 (3.5 mm) screws or bolts.
5. Mount the TB50 with four screws.
There are four smaller holes on the terminal board. Use these holes to secure wiring to the terminal
block with tie wraps.