Watlow CLS200 - Setup Loop Outputs Menu

CLS200 Series User’s Guide
Chapter 4: Setup
84
Setup Loop Outputs Menu
Use the SETUP LOOP OUTPUTS menu to:
• Enable or disable outputs
• Set output type
• Set cycle time for time proportioning outputs
• Enter Serial DAC parameters (for Serial DAC outputs)
• Select control action
• Set output level limit and limit time
• Select sensor fail output (output override)
• Select a nonlinear output curve
ALARM
SETUP LOOP 01
OUTPUTS ?
Table 4.11 shows the parameters available in the SETUP LOOP OUTPUTS menu. Both heat and
cool outputs have the same parameters; only one of each parameter is shown.
Table 4.11 — Setup Loop Outputs
PARAMETER DEFAULT VALUE
HEAT CONTROL OUTPUT? ENABLED
HEAT OUTPUT TYPE? TP
HEAT OUTPUT CYCLE TIME? 10s
SDAC MODE?* VOLTAGE
SDAC LO VALUE?* 0.00 VDC
SDAC HI VALUE?* 10.00 VDC
HEAT OUTPUT ACTION? REVERSE
HEAT OUTPUT LIMIT? 100%
HEAT OUTPUT LIMIT TIME? CONT
SENSOR FAIL HT OUTPUT? O%
HEAT T/C BRK OUT AVG? OFF
HEAT OUTPUT? LINEAR
COOL CONTROL OUTPUT? DISABLED
*
The SDAC parameters are available only if you select SDAC as the output type.
Use these parameters to configure the Serial DAC signal output.