Watlow CLS200 - Alarm Deadband; Manual I;O Test

CLS200 Series User’s Guide
Chapter 4: Setup
93
ALARM
01 ALARM DEAD-
BAND ? 2
Selectable values: 0 to 255, 25.5, 2.55, .255 or .0255, depending on the INPUT TYPE and
DISP FORMAT settings.
Alarm Delay
Set a loop alarm delay. This parameter delays failed sensor, process and deviation alarms until the
alarm condition has been continuously present for longer than the alarm delay time.
ALARM
01 ALARM DELAY ?
0 SECONDS
Selectable range: 0 to 255 seconds.
Manual I/O Test
This menu facilitates testing of:
• Digital inputs
• Digital outputs
• The keypad buttons
ALARM
MANUAL I/O
TEST ?
Table 4.14 shows the screens available in the MANUAL I/O TEST menu.
Table 4.14 — Manual I/O Test
PARAMETER DEFAULT VALUE
DIGITAL INPUTS HHHHHHHH
TEST DIGITAL OUTPUT? 1: IN USE
DIGITAL OUTPUT NUMBER XX? OFF
KEYPAD TEST N/A
DISPLAY TEST N/A
NOTE! The DIGITAL OUTPUT NUMBER screen appears only if an unassigned output has
been selected in the TEST DIGITAL OUTPUT screen.