CLS200 Series User’s Guide
Chapter 4: Setup
67
Setup Global Parameters Menu
ALARM
SETUP GLOBAL
PARAMETERS
Table 4.1 shows the parameters available in this menu.
Table 4.1 — Global Parameters
PARAMETER DEFAULT VALUE
LOAD SETUP FROM JOB? 1
SAVE SETUP TO JOB? 1
JOB SELECT DIG INPUTS? NONE
JOB SEL DIG INS ACTIVE? LOW
OUTPUT OVERRIDE DIG INPUT? NONE
OVERRIDE DIG IN ACTIVE? LOW
STARTUP ALARM DELAY? 0 MINS
RAMP/SOAK TIME BASE?* HOURS/MIN
KEYBOARD LOCK STATUS? OFF
POWER UP OUTPUT STATUS? OFF
PROCESS POWER DIGIN? NONE
CONTROLLER ADDRESS? 1
COMMUNICATIONS BAUD RATE? 19200
COMMUNICATIONS PROTOCOL? MOD
COMMUNICATIONS ERR CHECK? BCC
AC LINE FREQ? 60 HERTZ
DIG OUT POLARITYON ALARM? LOW
CLS200
[model no., firmware rev.]
* The RAMP/SOAK TIME BASE parameter appears only if the ramp/soak feature is installed.
Load Setup From Job
NOTE! Current settings are overwritten when you select a job from memory. Save your
current settings to another job number if you want to keep them.
Load any one of eight jobs saved in battery-backed RAM.
To Next Page
Loading...
