64
Chapter 4: Setup
The setup menus let you change detailed configuration information. This section describes how to
set up the controller using the built-in keypad and display. The following information is included in
this chapter:
• Accessing the setup menus
• Changing parameter settings
• Description of controller parameters
If you have not set up a CLS200 series controller before, or if you do not know what values to enter,
please read Chapter 7: Tuning and Control, which contains PID tuning constants and useful starting
values.
How to Access the Setup Menus
Use the three-key sequence to enter the setup menus:
1. Select the single loop display for the loop you wish to edit.
2. Press ENTER then ALARM ACK then CHNG SP to access the setup menus. Do not press
these keys at the same time; press them one at a time.
3. The first setup menu appears.
To prevent unauthorized personnel from accessing setup parameters, the controller reverts to the
single loop display if you do not press any keys for three minutes.
How to Change a Parameter
To change a parameter, first select the appropriate menu, then the parameter.
When you enter the setup menus, the first menu is SETUP GLOBAL PARAMETERS. Refer to
Figure 4.1 for a listing of all top level menus and their related parameters.
1. Select the single loop display for the loop to set up.
2. Enter the three-key sequence. The first menu is displayed: SETUP GLOBAL PARAMETERS.
To Next Page
Loading...
