Watlow CLS200 - Setup Global Parameters Menu; Edit Ramp;Soak Profile

CLS200 Series User’s Guide
Chapter 6: Ramp/Soak
118
Setup Global Parameters Menu
With the Ramp and Soak option, an additional menu appears on the SETUP GLOBAL
PARAMETERS menu.
Ramp/Soak Time Base
The RAMP/SOAK TIME BASE parameter is in the SETUP GLOBAL PARAMETERS menu.
Use this parameter to set the time base in all your ramp/soak profiles. When set to HOURS/MINS,
the setpoint is updated once every minute. When set to MINS/SECS, the setpoint is updated once
every second.
ALARM
RAMP/SOAK TIME
BASE? HOURS/MINS
Selectable values: HOURS/MINS (hours/minutes) or MINS/SECS (minutes/seconds).
Setup Ramp/Soak Profile Menu
The SETUP RAMP/SOAK PROFILE menu is located between the SETUP LOOP ALARMS and the
MANUAL I/O TEST menus if the ramp/soak option is installed.
ALARM
EDIT RAMP & SOAK
PROFILE? A
Press YES to set up or edit ramp/soak profiles.
Edit Ramp/Soak Profile
Choose a profile to set up or edit.
ALARM
EDIT RAMP & SOAK
PROFILE? A
Selectable values: A to Q (17 profiles).
Copy Setup From Profile
Set up similar profiles quickly by copying the setup of an existing profile.
ALARM
COPY SETUP
FROM PROFILE ? Q
Selectable values: A to Q.