Watlow CLS200 - CLS200 Parts List

CLS200 Series User’s Guide
Chapter 1: System Overview
15
CLS200 Parts List
You may have received one or more of the following components. See Table 1.1 – Ordering Options
for configuration information.
• CLS200 series controller
• Controller mounting kit
• TB50 with 50-pin SCSI cable
• EIA/TIA-232 or EIA/TIA-485 communications cable
• Special input resistors (installed in CLS200)
Table 1.1 — Ordering Options
CHARACTERISTIC OPTIONS DESCRIPTION
Number of Loops
4 Loops
The number of analog inputs and control
loops that can be controlled based on the
feedback from the analog inputs. There is an
additional control loop that uses feedback
from the pulse input.
8 Loops
16 Loops
Firmware
Standard
Includes closed-loop, PID control, auto-
tune, alarms, job memory and failed sensor
detection
Ramp and Soak
Provides the features of the standard version
plus the additional Ramp and Soak features
Enhanced Features
Provides the features of the standard version
plus the additional Enhanced Features
Digital I/O Termination
Screw Terminals (TB18) TB18 Terminal Block
Mass Termination (SCSI) SCSI Connector
Digital I/O Termination
Board Accessory
None No external terminal board included
TB50 Terminal Board TB50-SCSI (50 Pin terminal board)
Digital I/O Termination
Cable Accessory
None
Accessory cable to connect digital I/O
signals between the SCSI connector on the
controller and the TB50 board
3-foot SCSI cable
6-foot SCSI cable
3-foot SCSI cable with right angle
connector
Serial Communication
Jumper Settings
EIA/TIA-232
Application uses 232 communication or no
communication
EIA/TIA-485, not terminated
Application uses 485 communication, this
controller is not last in the network
EIA/TIA-485, terminated
Application uses 485 communication, this
controller is last in the network
Serial Communication
Cable
None No communication cable
10 foot communication cable
(DB-9 female/bare wires)
Cable for 232 communication
Mounting Hardware
Plastic collar and screw clips Standard mounting hardware
Low profile metal L-brackets and
screws
Mounting hardware for legacy applications
with tight fit
Customer Specific None Not applicable to standard product