CLS200 Series User’s Guide
Chapter 3: Using CLS200
50
NOTE! Pressing the NO key on power up performs a NO-key reset. This procedure
clears the RAM and sets the controller’s parameters to their default values. See NO-Key
Reset on page 150.
BACK Press BACK to:
• Cancel editing
• Return to a previous menu
• Switch between bar graph, single loop and job displays
• Stop scanning mode
ENTER Press ENTER to:
• Store data or a parameter choice after editing and go to the
next parameter
• Start scanning mode (if pressed twice)
CHNG SP Press CHNG SP to change the loop setpoint
MAN AUTO Press MAN/AUTO to:
• Toggle a loop between manual and automatic control
• Adjust the output power level of manual loops
• Automatically tune the loop
RAMP SOAK If your controller has the ramp/soak option, press RAMP/SOAK to:
• Assign a ramp/soak profile to the current loop
• Select the ramp/soak mode
• See the status of a running profile
Your controller may not have the ramp/soak option. If it does not,
pressing the RAMP/SOAK key displays the message OPTION
UNAVAILABLE.
ALARM ACK Press ALARM ACK to:
• Acknowledge an alarm condition
• Reset the global alarm output
To Next Page
Loading...
