www.Wayne-Dalton.com
349981 REV2_05/17/2016
©
Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation
30
Wiring (continued)
4. POSITION SENSOR WIRING CONNECTIONS AND SETTINGS
• The Position Sensor and bracket were mounted to the face of the
Motor/Gearbox in Section 4, Step 13. (See page 15)
A) Attach the chain to the Motor and Position Sensor sprockets.
Adjustment of the supplied chain may be necessary. FIG-5Oa
B) Attach one end of the M12 position sensor cable to the Position Sensor.
C) Attach the other end of the M12 position sensor cable to the Control
Panel.
Fig 5–Ob Position sensor Cable
FEMALE END VIEW
(TO CONTROL PANEL)
SHIELD
4
1
2
3
5 SHIELD
4
3
2
1
5
MALE END VIEW
(TO POSITION SENSOR)
POSITION SENSOR
SPROCKET
MOTOR SPROCKET
CHAIN
Fig 5–Oa
To Next Page
Loading...
