Wayne-Dalton 800 - Section 3 General Information; Job Site Issues and Considerations; Door Specifications

www.Wayne-Dalton.com
349981 REV2_05/17/2016
©
Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation
7
Section 3
General Information
The following list of items should be considered prior to installing an Advanced Performance Door.
• Verify the opening measurements, head room, and side room required for this installation.
• Type of door jamb.
• Availability of a power supply, which side of door it is on and what the line voltage is.
• Door system mounting environment. Items to consider include operator location, dampness of location, dustiness of the
location and corrosiveness of the location.
• Door activation needs and requirements. Examples include 3 button control stations, 1 button control stations, radio
controls, pull cords, loop detectors, photoeyes, key switches, motion detectors, etc.
• Accessory equipment needs and requirements. Examples include sirens, warning lights, etc.
Job Site Issues/Considerations
Door Specications
DOOR MODEL NUMBER (circle one): 800 / 800C
OPENING WIDTH:
OPENING HEIGHT:
CURTAIN COLOR:
OPERATOR VOLTAGE:
HEADROOM REQUIREMENT:
CURTAIN WEIGHT: __________
SIDE ROOM: DRIVE__________ NON-DRIVE:__________
GUIDE GAP __________ GUIDE TYPE___________
"S" DIMENSION __________ "G" DIMENSION__________
OPERATOR: HP _________ RATIO_________
MOTOR MOUNTING::INTERIOR or EXTERIOR
LEFT HAND or RIGHT HAND
(check one)
Installation Data
NAME PLATE SERIAL NUMBER:
JOB NAME:
DISTRIBUTOR:
NOTE: The ID plate is located on
the bottom bar.
Entrapment Protection
Photoeyes and sensing edges are required for all electrically operated Advanced Performance
Option Service doors. Both photoeyes and sensing edge are standard with these models. Do NOT
disable them.
1-800-827-3667 (DOOR)