Webasto Thermo Top C Installation Instructions

Thermo Top C, E Peugeot 307
50
Combustion air intake pipe
NOTE:
Note the installation position of the air intake silencer,
see the Installation Instructions.
- Put the combustion air intake line (1) with the cut
open side on the heater unit combustion air
supports and fasten with the hose clamp.
- Turn the combustion air intake silencer (2) in to the
stop in the combustion air intake line.
- Run the combustion air line according to the figure.
- Punch out perforated hole in the heater unit cover.
- Insert retaining clip (3) in the bore hole.
- Insert the combustion air intake silencer (2) in the
retaining clip (3) as shown in the figure.
Final work
- Install and connect the vehicle battery
- Reassemble disassembled components in reverse
order.
- Check that all hose lines, hose and tube clamps,
and all electrical connections are securely fastened.
- Secure all loose lines using cable clips.
- Remove tools, such as vice-grip wrenches etc. from
the engine compartment
- Spray heating unit components with anti-corrosion
wax (Tectyl ML, Order No. 111329).
- Start engine, bleed water circuit according to the
repair instructions, fill up with coolant.
- Switch on the Webasto heating, see "Operating and
Maintenance Instructions"
NOTE:
Fill out the installation confirmation on the back side of
the EG type approval and give this to the customer.
136
1
3
2

Webasto Thermo Top C Specifications

General

Brand	Webasto
Model	Thermo Top C
Category	Water Heater
Language	English