WEG CFW500 - Indications on the Hmi Display

28 | CFW500
HMI (Keypad) and Basic Programming
English
4.2 INDICATIONS ON THE HMI DISPLAY
Inverter status
Secondary indication
Measurement unit
(it refers to the value
of the main indication)
Bar graph
Menu (to select the
parameter groups) -
only one parameter
group is shown
at a time.
Main display
Figure 4.2: Display fields
Parameter groups available in the field Menu:
 PARAM: all parameters.
 READ: reading parameters only.
 MODIF: parameters modified in relation to the default only.
 BASIC: parameters for basic application.
 MOTOR: parameters related to the control of the motor.
 I/O: parameters related to digital and analog inputs and outputs.
 NET: parameters related to the communication networks.
 HMI: parameters to configure the HMI.
 SPLC: parameters related to SoftPLC.
 STARTUP: parameters for oriented Start-up.
Status of the inverter:
 LOC: command source or local references.
 REM: command source or remote references.
 : direction of rotation by means of arrows.
 CONF: configuration error.
 SUB: undervoltage.
 RUN: execution.