WEG CFW500 - Codes and Standards; Certifications

46 | CFW500
Technical Specifications
English
8.2.1 Codes and Standards
Table 8.2: Codes and standards
Safety
standards
 UL 508C - power conversion equipment.
Note: Suitable for Installation in a compartment handling conditioned air.
 UL 840 - insulation coordination including clearances and creepage distances
for electrical equipment.
 IEC/EN 61800-5-1 - safety requirements electrical, thermal and energy.
 EN 50178 - electronic equipment for use in power installations.
 IEC/EN 60204-1 - safety of machinery. Electrical equipment of machines. Part
1: general requirements.
Note: for the machine to comply with this standard, the manufacturer of the
machine is responsible for installing an emergency stop device and equipment
to disconnect the input power supply.
 IEC/EN 60146 (IEC 146) - semiconductor converters.
 IEC/EN 61800-2 - adjustable speed electrical power drive systems - part 2:
general requirements - rating specifications for low voltage adjustable frequency
AC power drive systems.
Electromagnetic
compatibility (EMC)
standards
 IEC/EN 61800-3 - adjustable speed electrical power drive systems - part 3:
EMC product standard including specific test methods.
 CISPR 11 - industrial, scientific and medical (ISM) radio-frequency equipment
- electromagnetic disturbance characteristics - limits and methods of
measurement.
 IEC/EN 61000-4-2 - electromagnetic compatibility (EMC) - part 4: testing and
measurement techniques - section 2: electrostatic discharge immunity test.
 IEC/EN 61000-4-3 - electromagnetic compatibility (EMC) - part 4: testing and
measurement techniques - section 3: radiated, radio-frequency, electromagnetic
field immunity test.
 IEC/EN 61000-4-4 - electromagnetic compatibility (EMC) - part 4: testing and
measurement techniques - section 4: electrical fast transient/burst immunity test.
 IEC/EN 61000-4-5 - electromagnetic compatibility (EMC) - part 4: testing and
measurement techniques - section 5: surge immunity test.
 IEC/EN 61000-4-6 - electromagnetic compatibility (EMC) - part 4: testing and
measurement techniques - section 6: Immunity to conducted disturbances,
induced by radio-frequency fields.
Mechanical
construction
standards
 IEC/EN 60529 - degrees of protection provided by enclosures (IP code).
 UL 50 - enclosures for electrical equipment.
 IEC/EN 60721-3-3 – classification of environmental conditions - part 3:
classification of groups of environmental parameters and their severities - section
3: stationary use at weather protected locations level 3m4.
8.3 CERTIFICATIONS
Certifications (*) Notes
UL and cUL E184430
CE
IRAM
C-Tick
EAC
(*) For updated information on certifications, please contact WEG.