WEG CFW500 - Page 35

30 | CFW500
HMI (Keypad) and Basic Programming
English
NOTE!
When the inverter is in the fault state, the main display indicates the number
of the fault in the format Fxxxx. The browsing is allowed after the activation
of the key ESC, and the indication Fxxxx goes to the secondary display until
the fault is reset.
NOTE!
When the inverter is in the alarm state, the main display indicates the number
of the Alarm in the format Axxxx. The browsing is allowed after the activation
of any key, and the indication Axxxx goes to the secondary display until the
situation causing the alarm is solved.
NOTE!
A list of parameters is presented in the quick reference of the parameters. For
further information about each parameter, refer to the programming manual
of the CFW500.