DTV 720 USER’S MANUAL
800043-01 Rev. C 30 www.wegener.com
Second-Level Serial No.and Application Software Version Screen
Where XXXXXX is the unit's six-digit serial number and YYY is the version number of the
unit's currently installed application software.
Press the ESC key to return to the Home screen.
Alarms/
Warnings
Screen
Press the ENT key to view any active alarms or warnings on the second-level Alarms/
Warnings Message screen.
Press the ww key to go to Clear Errored Seconds (if counter is non-zero) or Program Setup.
Press the ESC key to go to the Home screen.
Alarms/Warnings Message Screen
Any active alarms or warnings are described here.
Press the ww key to view the next alarm or warning (if more than one is present).
Press the ESC key to return to the Alarms/Warnings screen.
Clear Errored
Seconds
Screen
Press ENT to clear the Errored Seconds counter.
Press the ww key to go to the Input Setup screen.
Press the vv key to go back to the Alarms/Warnings screen.
Press the ESC key to go to the Home screen.
Input Setup
Screen
The Input Setup screen and its subscreens are used to enable and set parameters of ASI
and RF inputs.
Press the ENT key to bring up the second-level Input Setup screen.
Press the ww key to go to the Program Status screen.
S/N: XXXXXX
Version: YYY
View Alarms/Warnings
No Alarms or Warning
Clear Errored Secs
Press<ENT>
Input Setup...
To Next Page
Loading...