Wegener DTV 720 - Program Status Screen; Front Panel Timeout Screen

DTV 720 USER’S MANUAL
www.wegener.com 33 800043-01 Rev. C
Program
Status
Screen
Press the ENT key to view the second-level Program Status screens.
Press the ww key to go to the Front Panel Timeout screen.
Press the vv key to go to the Input Setup screen.
Press the ESC key to go to the Home Screen.
Second-Level Program Status Screens
where XXXXX is the program number at input, AAAAAAA is the service descriptor for the
program, YYY is Yes or No, indicating whether or not the program is multiplexed into the
output stream, and BBBBBBB is the available audio on the input for the program (AC-3,
MPEG, or MPG/AC3).
Press the ww key to view the status of the next program.
NOTE: All programs present may be viewed but only programs 1 through 16 may be
selected for output.
Press the ESC key to return to the Program Status screen.
Front Panel
Timeout
Screen
After a period of inactivity, some information on the LCD is replaced with Help information
on how to use the front-panel controls. This timeout period (elapsed time between the last
front-panel activity and presentation of Help information) may be changed using the Front
Panel Timeout screen. For users familiar with front-panel operation, selecting No Timeout
will prevent the Help information from appearing. Other users may wish to set the timeout
period from 3 to 60 seconds.
Press the ENT key and then the rr or ss keys to select the Front Panel Timeout period
before the Help message is displayed. Values of 3, 5, 10, 30, or 60 seconds, or No Timeout
may be selected.
Press the ENT key to confirm the selection or ESC to cancel changes.
Press the ww key to go to the IP Setup screen.
Press the vv key to go back to the Program Status screen.
Press the ESC key to return to the Home screen.
Program Status...
ProgIn XXXXX AAAAAAA
Out: YYY BBBBBBB
Front Panel Timeout
10