Weidmüller maxGUARD - - 1 X AMG ELM-4 F

28Manual maxGUARD2526740000/02/03.2018
4 Conguration | Example congurations
Example: One segment with connection to a control unit
Example: maxGUARD station with connection to a control unit
This example shows a control voltage distributor for six se-
lectively fused load circuits with connection to a control unit.
The following maxGUARD products are used:
– 1xAMGFIM-C
– 1xAMGELM-6
– 1xAMGELM-4F
– 1xAMGELM-Q2222
– 1xAMGPD
– 2xAMGOD
– 1xAMGMD
– 1xAMGXMD
– 2xAMGEP
– 2xWEW35/2
– 1xZQV4N/50RD, 1xZQV4N/3RD, 1xZQV4N/2RD
– 1xZQV4N/50
– 1xZQV4N/50BL, 2xZQV4N/3BL
The active feed-in module feeds in the supply voltage and
connects the station to the control unit.
The potentials are distributed to the individual modules via
cut cross-connectors. As the total current owing through
the station is less than 20A, the main strands are each
equipped with only one cross-connector. The internal signal
line is established via a cut cross-connector.
The outputs of the load monitors are replicated using poten-
tial distribution terminals. The potential distribution terminals
are connected to the outputs of the load monitors via uncut
cross-connectors.
The station must be equipped with end plates at both ends.
Only then will the exposed cut edges of the cut cross-con-
nector be insulated and the exposed side of the last potential
distribution terminal covered.