上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
27 / 61
4 Quick Start
4.1 Overview
This section gives you an introduction of a simple machining process with the NcStudio
Phoenix Three-axis Engraving System:
4.2 Loading a Machining File
Before starting machining, you need to load the machining program first.
For details, see section 5.1.1 Loading a Program.
4.3 Running Simulation
During simulation, the system does not drive machine movement or consume machine or
workpiece resources. Only the machining path and process are displayed in the software
for you to spot possible problems and edit the program accordingly.
Follow the steps below to run simulation:
1. In Auto or Manual mode, select one from the following methods to access
simulation mode:
o In the operation button bar, click Simulate.
o In the menu bar, go to Machine > Simulate.
2. Select one from the following methods to start simulation:
Press the F9 key.
In the operation button bar, click .
In the menu bar, go to Machine > Cycle Start.
The simulation track is displayed in the Track tab of the function window.