上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
30 / 61
2. Select a tab and set the parameters based on the left figure.
3. Click Execute. The system starts machining.
5.3 Single Block Machining
In this mode, the program commands will be executed line by line for you to check the
machine movement.
Follow the steps below to execute single block machining:
1. In Auto mode, go to Machine > Single Block Execution in the menu bar to enable
single block machining mode.
2. Select one from the following methods to make the system run a command line and
pauses:
o Press the F9 key.
o In the operation button bar, click .
o In the menu bar, go to Machine > Cycle Start.
3. Repeat step 2 to make the system run the next command line until all commands
are executed.
5.4 Selective Machining
In this mode, you can specify the start and end command line number to run the target
commands.
Follow the steps below to use selective machining:
1. Select one from the following methods to open the Selective MC dialog box:
To Next Page
Loading...