Configuration
Wieland Electric GmbH | BA000966 | 07/2016 (Rev. C)
Configuration
888528267
Check the protective function before commissioning and after any change!
If you change the configuration, you must check the effectiveness of the protective function.
To this end, note the test instructions in the operating instructions for the connected safety
equipment.
Additional information
For configuring the samosPRO system, you will require the samosPLAN5+ software and the
program removable storage.
The configuration and verification of devices that are connected to the safety control generally
does not take place using the samosPLAN5+ software. These devices have their own mecha-
nisms for configuration and verification.
• The system configuration of the entire samosPRO system is stored in the SP-COP-CARD1
program removable storage. This has the advantage that the system does not have to be
reconfigured when modules and/or gateways are replaced.
• The data stored in the program removable storage will be retained even if the supply vol-
tage is interrupted.
• It is possible to transfer configuration information via the USB or Ethernet interface.
To Next Page
Loading...
