WinGD W-X82 - Page 23

Operation
0030−1/A1
Winterthur Gas & Diesel Ltd.
1/ 5
Alphabetical Table of Contents
A
Abbreviations 0035−1/A1.......................................................................
Adjustment − Feed Rate 7218−3/A1..............................................................
Air flaps in the scavenge air receiver 6420−1/A1...................................................
Alarms and safeguards at continuous service power 0250−2/A1.....................................
Auxiliary blower and switch box 6545−1/A1........................................................
Auxiliary blower, failure of... 0550−1/A1...........................................................
Axial damper 3140−1/A1........................................................................
B
Bleed the lubricating pump 7218−1/A1............................................................
C
Change-over from diesel oil to heavy fuel oil and back 0270−1/A1....................................
Checks, engine controls 4003−1/A1..............................................................
Cleaning the cooling water system 0760−1/A1.....................................................
Cleaning the scavenge air cooler in operation 6606−1/A1...........................................
Cleaning the turbocharger during operation 6510−1/A1.............................................
Compressed air, starting air, control air 0740−1/A1.................................................
Control air supply 4605−1/A1...................................................................
Control diagram, designations 4003−2/A0.........................................................
Control diagram 4003−2/A1.....................................................................
Connecting rod, connecting rod bearing 3303−1/A1................................................
Cooling water system 8017−1/A1................................................................
Cooling water treatment 0760−1/A1..............................................................
Crank angle sensor unit 9223−1/A1..............................................................
Crankcase explosions, prevention of... 0460−1/A1..................................................
Crosshead and guide shoe 3326−1/A1............................................................
Cut out an exhaust valve control unit 0520−1/A1...................................................
Cylinder liner 2124−1/A1........................................................................
Cylinder liner, running-in of new... 0410−1/A1......................................................
Cylinder Lubrication 7218−1/A1..................................................................
Cylinder lubricating oil supply unit 7218−1/A1......................................................
Cylinder lubricating system, control
7218−1/A1....................................................
Cylinder lubricating system, procedures before taking into service 0140−1/A1..........................
D
Damage to engine parts 0840−1/A1..............................................................
Defective remote control system 0560−1/A1.......................................................
Drainage system and wash-water system 8345−1/A1...............................................
Draining cooling water 8017−1/A1................................................................
Drive supply unit 4104−1/A1.....................................................................
Subject Index
2014